WinnFreeNet.com

‘My GE has started making clicking noises during the agitation cycle. Then it stopped agitating at all, then started up again. It seems to have trouble agitating with a larger load. At first it was spinning OK, but now the clicking happens during the spin cycle, too.’ My washing machine works fine until it gets […]

I recently discovered a serious security issue affecting some default Hamvoip node setups. This is likely in all nodes based on that image and needs to be fixed or you need to take your nodes webpage off the internet. Close your ports.

We had problems with bots using up all the bandwidth this is being worked on. The pages with excessive loads  have been removed until i fix the problem. Updates: So there were problems with cemetery listings on some of my sites bots are trying to scrap the data but the excessive load ran over bandwidth […]

“The Little Men,” a book by Omri Revesz published in 1941. In this story, little men represent different parts of the body, and they work together to keep the body functioning properly. It’s a charming and educational book that was popular during its time.

First add the deb to your sources Add this at the bottom save and exit then You have to add the key or it wont work. Now you can install by APT Now you can navigate from your browser to http:/yourip:1000 And get the above admin screen. Webmin is great for editing startup chron log […]

There really is nothing online about using the cm108 with OpenRepeater or SVXLINK you really have to dig. No docs or anything. Follow instructions to add the cm108 to the OS Wp wont let me type the above so its a image.   This adds support in the OS. Then place OpenRepeater in advanced mode […]

Instructions to add the RTC are not the same as the PI so take care. First install the wiring tool. sudo apt update sudo apt install libretech gpio libretech dtoverlay Then install the overlays sudo ldto enable i2c-ao sudo ldto enable i2c-ao-ds3231 Check that 68 displays in the center of the chart by typing sudo […]

Iris v1 Keypad is compatible with Hubitat (H-7) only when my driver is used. It is the best keypad for use with Hubitat. You can get them on ebay at low cost because no one knows how to make them work. It will not pair on h8 due to a chip set problem in the […]

This is my driver for ZWAVE Radio Thermostats to solve problems with the original drivers.     radio_thermostat_zwave.groovy   Import URL RAW code Zwave Radio Thermostat Hubitat driver Hubitat driver for radio thermostat & Iris Thermostat Radio Thermostat Company of America (RTC) Supports poll chron, time set chron,humidity,heat or cool only,C-wire,Diff,Recovery mode,Mans detection setpoint restore from […]

How to reset and add your Iris v1 keypad to Hubitat. First install the driver. Import from this url https://raw.githubusercontent.com/tmastersmart/hubitat-code/main/iris_v1_keypad.groovy Reset Device: Insert two batteries side-by-side at one end or the other and then press “ON” button device 5 times (8 times?) within the first 10 seconds. Device will reset and start flashing. Add device […]

ATT Fixed wireless uses a U-verse gateway router 5268AC with custom firmware.   It uses a special antenna IFWA661 NetComm Wireless Limited Outdoor LTE Router with a POE injector.  FCC ID https://fccid.io/XIA-IFWA661    Most of the setup options in the gateway that you normally see online for a 5268AC have been removed  no port forwarding is […]