Reset and add Iris keypad v1 for 2022
How to reset and add your Iris v1 keypad to Hubitat.
First install the driver. Import from this url
https://raw.githubusercontent.com/tmastersmart/hubitat-code/main/iris_v1_keypad.groovy
Reset Device:
Insert two batteries side-by-side at one end or the other and then press “ON” button device 5 times (8 times?)
within the first 10 seconds. Device will reset and start flashing.
Add device using iris add system. Keypad will likely add as a care switch. Go to device setup and change driver to “Iris v1 Keypad” and save.
Press init and conf if they dont atomically run.
Add keypad to safety manager.
If not installed install Lock Code Manager. And add users and codes.
If you have existing users check each user to make sure they are added.
lock code manager has no error checking. If you see problems you will have to delete codes and readd.
Go to keypad setup .
IRIS has ON ,Part, * and # these buttons can be mapped to HOME, AWAY, NIGHT.
Silent arming is also possible. There are several possible tones for the alarm set the one you like.
Routines will now have access to the tones. Keypad supports 13 different chimes under play command
Button driver will now see 10 buttons these can be mapped to anything.
You will have to create a routine to monitor the panic button and tamper.
Tamper goes active when a bad pin is entered.
I think you will agree that this is the best keypad for hubitat
