Using cm108 soundcard on OpenRepeater SVXLINK
There really is nothing online about using the cm108 with OpenRepeater or SVXLINK you really have to dig. No docs or anything.
Follow instructions to add the cm108 to the OS
Wp wont let me type the above so its a image.
This adds support in the OS. Then place OpenRepeater in advanced mode by going to. http://yourIP/advanced.php
And add the following to
RX
SQL_DET=HIDRAW
HID_DEVICE=/dev/hidraw0
HID_SQL_PIN=!VOL_DN
the ! reverses the port.
Add the following to TX
HID_DEVICE=/dev/hidraw0
PTT_TYPE=Hidraw
PTT_PORT=/dev/hidraw0
HID_PTT_PIN=!GPIO3
The PPT pin is !GPIO3 on the soundcard not the PI GPIO the COS pin is !VOL_DN If your using a transistor to reverse the lines don’t use the ! You could also modify the file direct but Open repeater will overwrite you settings. Open Repeater must be in advanced mode. SO set everything else in open repeater then switch to advanced and make a back up of the file in case open repeater overwrites it later.
I use WEBMIN you can install it by using these instructions
